Different values have been replaced with different options see the table below. Select network device to be used at early stage of installation. These options have been consolidated under the ip= option. netmask=, gateway=, hostname=, ip=, ipv6= dns=Ĭonfigured the Domain Name Server (DNS). The difference is now detected automatically, which means this option is the same as inst.repo=nfs: server:/ path. In NFS installations, specified that the target is an ISO image located on an NFS server instead of an installable tree. method=Ĭonfigured the installation method. Used to specify that the machine being installed onto does not have any display hardware, and to prevent the installer from trying to detect a display. The blacklisted drivers can then be found in the /etc/modprobe.d/ directory. Drivers (mods) disabled using this option will be prevented from loading when the installation starts, and after the installation finishes, the installed system will keep these settings. modprobe.blacklist=īlacklists (completely disables) one or more drivers. Specifies a timeout period (in seconds) the installer will wait before starting the X server. This option is equivalent to inst.xdriver=fbdev. Tells the installation program to use the frame buffer X driver instead of a hardware-specific driver. Specifies the name of the X driver to be used both during the installation and on the installed system. The lowest supported resolution is 800圆00.
Where N is the screen width and M is the screen height (in pixels). Specifies the screen resolution in graphical mode. This mode does not allow any interaction,Īll options must be specified in a Kickstart fileįorces the installation program to run in graphical mode. inst.cmdlineįorces the installation program to run in command line mode. It is recommended to use VNC as described inĮnabling Remote Access Using VNC. When installing a system on a machine with a limited graphical capabilities, It does not allow you to modify the partition layout or set up LVM. The text user interface is limited, for example, inst.textįorces the installation program to run in text mode instead of graphical mode. Layout codes are the same as the ones used in the keyboard Kickstart command as described in keyboard (optional) - Configure Keyboard Layouts.
Specifies the keyboard layout to be used by the installation program. If this option is not specified, Anaconda will use provider_fedora_geoip.
0 kommentar(er)
